Admin Table of Contents
Why is my electronic speedometer not working?
If your speedometer stopped working and stays at 0 MPH, you should have your car checked ASAP. The most common causes of a speedometer that stopped working include are a faulty speed sensor, a broken gear on the speedometer, damaged wiring, or a faulty engine control unit.
Can a blown fuse cause the speedometer not to work?
Faulty Fuse/Bad Wiring: In very wet conditions, it is possible for exposed wires to get wet and short out, causing a fuse to blow. When the fuse for your speedometer stops working, it can cause the speedometer to drop to zero.
How much does it cost to fix RPM gauge?
The average cost of a replacement tachometer costs anywhere between $60 and $260 on parts alone. Other factors that may affect the price include the brand, memory recall features, mounting style, operation, range, and more.
What to do if your fuel gauge is not working on Nissan?
If this does not repair the problem, replace the temp gauge in the dash. Locate the fuel sending unit on your Nissan by consulting the manual for your model car. Identify the sending wire to the unit and the ground wire (the ground will most likely be black and will terminate nearby to the car frame).
Is there a repair service for the instrument cluster on Nissan Maxima?
This repair service is for an existing 2000, 2001, 2002, and 2003 Nissan Maxima instrument cluster. This repair service will correct gauge and backlighting issues. Our rebuild service eliminates the need for any…
How do I change the temperature sending unit on a Nissan?
Trace the wire from your temp gauge back into the engine to your Nissan temperature sending unit. Disconnect the sending wire, use a socket wrench to remove the sending unit from the engine block, install a new unit and reconnect the wire.
How do you clean the inside of a fuel gauge?
Pry off the rubber gasket from around your fuel & temp gauges on your dash with a flat-head screwdriver. Withdraw the gauges from the dash and disconnect the wires. Rub a pencil eraser on both ends of the electrical connections to clean any corrosion from them.