Table of Contents
Why is my Smeg dishwasher not filling with water?
If your dishwasher has not been able to fill with water the inlet valve that lets water into your machine could be faulty. It’s also worth checking that the tap that connects your water supply to your dishwasher is on completely and that the inlet hose is not kinked or squashed.
Why is there no water coming into my dishwasher?
The reason for water not going into your dishwasher could be that a float is stuck in the shut-off position, preventing water delivery. If that’s the case, homeowners should call technicians to assess float assembly and replace the component if needed.
Why is my Smeg dishwasher not working?
The Basics A Smeg dishwasher not starting could simply be a problem with the power supply – the appliance won’t start if water is unable to be drawn from the mains water supply. And then the dishwasher should verify the setup and start of a wash cycle. If this isn’t happening the power outlet itself may be at fault.
How do I reset my Smeg dishwasher?
How to Reset a Smeg Dishwasher
- Open the dishwasher door and quickly close it.
- Locate the “On/Off” button on the left side of the dishwasher control panel.
- Select and run a dishwashing cycle to ensure that the dishwasher control board has been reset successfully.
What happens when dishwasher float is not working?
The float triggers the float switch to shut off, thereby shutting off the flow of water into the dishwasher. The float in your dishwasher needs to be able to move up and down freely. If it should happen to get stuck, it could interfere with your dishwasher’s ability to fill and/or drain.
How do you reset a Smeg dishwasher?
Reset your Smeg dishwasher to have it working again as soon as possible.
- Open the dishwasher door and quickly close it.
- Locate the “On/Off” button on the left side of the dishwasher control panel.
- Select and run a dishwashing cycle to ensure that the dishwasher control board has been reset successfully.
How do I reset a Smeg dishwasher?
How do I reset my dishwasher?
To reset a dishwasher, you need to hold the start button down for three seconds or, failing that, switch your dishwasher off at the main power supply. If that won’t sort out the glitch, you may have problems with your power, water source, door latch, or internal issues.
How do I troubleshoot my Smeg cse66-i2 dishwasher?
Smeg CSE66-I2 dishwasher troubleshooting. Problem. Solution. If the program fails to start, check that: • the dishwasher is connected to the electrical power supply, • there is no power failure; • the water tap is open; • the dishwasher door is properly closed.
Why does my dishwasher float switch not disengage?
If the float has got stuck or been blocked by debris then it won’t fall back down as the water is drained. As a result the float switch won’t disengage which will prevent the inlet valve from opening and allowing water into the dishwasher.
Why is my dishwasher not filling up with water?
A malfunctioning float could cause the dishwasher to not fill with water. The acts as a safety device that prevents the dishwasher from overfilling with water. The float rises with the water level in the dishwasher and when the proper level is reached, the float will trigger the float switch to turn off the water inlet valve.
Why is my Kenmore dishwasher not heating the water?
The heating element is not working The heating element serves to heat the water inside your dishwasher. If this component is defective, the water will not heat up and will not dry the items loaded into your appliance. You can test the heating element using a multimeter in ohmmeter mode.