Admin Table of Contents
Here we have some examples of the valet button/switch: It is usually located under the dash on the driver or passenger side. It is a plastic box with wires coming out of it.
How do I turn valet mode off?
How to Exit Valet Mode
- Insert your vehicle’s key into the ignition and turn to the “ON/RUN” position. Do not crank the engine.
- Press and release the LOCK and TRUNK buttons (I & III) simultaneously.
- Remove the key from the ignition and attempt to remote start your vehicle.
What is a valet switch on a car?
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational.
What is valet mode Chevy?
Valet mode disables all system features other than lock or unlock; such as, remote start, alarm triggers, and trunk release. Valet mode can be temporarily activated to prevent unintended use of the system’s many features.
How do I reset my valet remote starter?
Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.
How do you get code alarm out of valet mode?
To enter or exit valet mode simply follow the 4 steps outlined below: Turn the vehicle’s ignition ON. Push and hold the programming/valet button….To by-pass the alarm system:
- Open the vehicle door.
- Turn the ignition key to the ON position.
- Within 10 seconds, press and release the valet push button switch.
How do I resync my remote starter?
Does valet mode disable pin to drive?
Valet mode is perfect for these situations. It hides your addresses, locks the glove box, limits the speed and you don’t have to turn off and then reset you Pin to Drive.
Where is the valet switch located on a Toyota Corolla?
Location of the VALET switch will vary as the location is determined by the installer. In some rare instances, the installer may not install the VALET switch. Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel.
Where is the valet switch located on a 2004 Chevy Silverado?
Low in the center console in the back of a pocket. Along side of the fuse block. In the glove compartment. Newer systems will have a glass-mounted antenna. The valet switch is on this antenna. If you do not locate your valet switch please refer to your installer/dealer to have them locate the Valet Switch.
How to enter valet mode on Chevy Cruze?
How to Enter “Valet Mode” 1 Turn the vehicle key in the ignition to the ‘On’ position. 2 Press and release the lock button and the trunk button simultaneously (buttons I & III). 3 Holding the buttons for over .5 seconds will cause this to fail. More
How do I use the valet button or switch?
The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode. 1.