Where is the starter motor on a SLK 230?

Where is the starter motor on a SLK 230?

The upper one is located on the left side of the engine below the intake manifold.

What are the steps to replacing a starter?

How to Replace a Starter-Mounted Solenoid

  1. Remove the starter.
  2. Remove the field coil strap from the solenoid terminal.
  3. Remove the attaching screws and bolts and remove the solenoid housing.
  4. Install the new solenoid in the reverse order of removal.
  5. Reconnect the cable and wiring when you install the starter.

What would cause a Mercedes not to start?

Systems to Check to Troubleshoot a Mercedes-Benz Starting Issue. Other issues preventing start can include ECM / PCM computer failure electrical problems, or issues with the camshaft position sensor, shifter selector module, or the driver authorization or immobilizer device.

How much is a Mercedes starter?

Mercedes starter typically cost between $111.99 and $269.99.

Can you change a starter yourself?

You can buy a new starter, which is rather expensive, or you can buy a rebuilt starter, which is just as good as a new one [source: Allen]. If the problem is really your starter, save yourself a trip to the mechanic and replace it yourself. Disconnect all the bolts that hold the starter to the block, using a ratchet.

Is replacing a starter easy?

Replacing a car’s starter motor isn’t difficult. However, vehicles with large engines will be more challenging. In this post, you’ll learn how difficult it is to replace a starter motor on both front-wheel drive and rear-drive cars.

What causes a Mercedes Benz not to start?

How much is a starter for a Mercedes Benz?

Why wont my car start if it’s not the battery?

If your vehicle won’t start, it’s usually caused by a dying or dead battery, loose or corroded connection cables, a bad alternator or an issue with the starter. It can be hard to determine if you’re dealing with a battery or an alternator problem.

What does it mean when you turn your key and nothing happens?

If nothing happens when you turn the ignition key to the “Start” position, it means that the starter motor doesn’t turn over the engine. Most commonly this could be caused by a dead battery; read above How to check the battery.