Admin Table of Contents
Where is the fuse box on a 2008 Chrysler PT Cruiser?
The fuse access panel is on the left side of the instrument panel next to the steering column. To remove the panel, pull it out, as shown. A label identifying the components and circuits is located on the inside of the cover.
What is the IOD fuse?
The ignition Off Draw (IOD) fuse is used to prevent battery discharge during shipping or long-term storage of the vehicle. The IOD fuse is located in the Total Integrated Power Module (TIPM). If the fuse is not completely inserted, partial contact of the fuse terminals could occur.
Where is the horn fuse on a 2008 Dodge Avenger?
The horn fuse on the 2008 Dodge Avenger is going to be located in the fuse panel in the engine compartment under Your car’s hood. Pop that open, and look at the driver’s side, almost to the chassis, and You’ll see a long black plastic cover. That’s the top of Your fuse box.
How do I reset my TIPM?
How To Perform a TIPM Hard Reset
- Remove ignition key.
- Remove the negative cable from the battery.
- Remove the positive cable from the battery.
- Keeping cables completely clear of the battery, hold both the positive and negative cables together for 10 minutes.
Where is the IOD fuse on PT Cruiser?
Where Is the IOD Fuse Located?
| Vehicle | TIPM / IOD Fuse Location |
|---|---|
| Chrysler PT Cruiser (2001-2010) | engine compartment near the air cleaner assembly – a description of each fuse and component may be stamped on the inside of the cover |
| Dodge Grand Caravan (2005) | left side of the fuse box under the hood, near the battery |
What does no fuse mean on a PT Cruiser?
Its your IOD fuse. If the odometer ever reads NO FUSE, your IOD is blown 85% of the time. It stops anything from drawing power off the battery, radio, power locks, etc.
Where is the fan relay on a 2008 Dodge Avenger?
The 2008 Dodge Avenger cooling fan relay location is in the fuse boxBy the steering wheel. To get to the fuse box look to the left of the steering wheel look for a small seam or crack along the dash. Using a screwdriver or prybar You will want to pop this open.
Where is the ignition relay on a 2008 Dodge Avenger?
The 2008 Dodge Avenger does not have a starter relay. The functionality is integrated into the TIPM module, which You’ll find on the leftmoSTSide of the engine compartment. There is little You can do with this by way of isolated diagnosis.
What are the signs of a bad TIPM?
Typical symptoms of a TIPM failure
- The fuel pump not turning off and burning out.
- The airbags not deploying OR deploying randomly.
- The engine stalling while driving.
- The starter cranks but won’t start.
- The horn going off at random times.
- Power windows not working.
- Doors locking or unlocking themselves.