Admin Table of Contents
Where is heater blend door actuator located?
The Blend Actuator Motor is located on the Hvac Box underneath the dashboard. The exact location of the Actuator will depend on the Make, Model and Year of the vehicle serviced….Where is the heater blend door actuator located?
| CALLOUT | COMPONENT NAME |
|---|---|
| 1 | Left temperature actuator screws |
| 2 | Temperature blend actuator |
How do you change the blend door actuator on a Chevy Impala?
Starts here6:32How to Replace a Blend Door Actuator Chevy Impala – YouTubeYouTubeStart of suggested clipEnd of suggested clip59 second suggested clipThis little part right here has to go. Up on that white. Piece. Right back up in there. And uh it’sMoreThis little part right here has to go. Up on that white. Piece. Right back up in there. And uh it’s easy if you can grab that which you can you grab it and you just kind of rotate.
How many actuators does a Chevy Impala have?
The Impala is equipped with dual climate control and up to three actuators. When they malfunction, drivers witness loud “clacking” or “clicking” noises from under the dash.
Will a blend door actuator cause no heat?
If the door moves easily, then the problem is in the blend door actuator or the heater control head. If the motor fails when the door is closed, that could cause a no heat in car condition. During air conditioning season, a bum blend door actuator can fail in a full or partially open position.
How do I replace the driver side blend door actuator?
The driver-side blend door is accessed by removing the IP instrumental panel. Once the panel is off, simply loosen the actuator mounting screws and disconnect it from the HVAC system. Then replace the unit.
How does a heater blend door work?
The heater blend doors act as a gateway to the vehicle’s ventilation system. When heat is built up inside of the heater core, the actuator door shifts to allow the hot air through the system, and when the climate control is turned to cool, the door flaps in the other direction closing off the heater core.
How does the Chevy Silverado blend door work?
When heat is built up inside of the heater core, the actuator door shifts to allow the hot air through the system, and when the climate control is turned to cool, the door flaps in the other direction closing off the heater core. Unfortunately, the blend doors on the Chevy Silverados contain plastic gears that tend to strip easily.
How do I calibrate the HVAC actuator?
After installation of any of the HVAC actuators, they must be calibrated. The dealer uses the Tech-2 device. The home mechanic can disconnect the negative battery terminal for five minutes, then reconnect it. Start the car and do not touch the HVAC controls. The HVAC system will perform a self-calibration which takes about two minutes.