What is the safety margin on tools with saw blades?

What is the safety margin on tools with saw blades?

Maintain a two-inch margin of safety. Keep your hands on either side of the blade, not in line with the blade. Use a push stick to feed small pieces through the saw and to remove scraps from around the blade.

When cutting material What is the minimum distance the hands should be kept from the blade quizlet?

Keep your hands away from the cutter head even though the guard is in position. Maintain at least a 4 in. margin of safety!

What is the distance between the fence and the blade where the use of a push stick is indicated?

Always use a push stick when the fence is set under 75mm (3”) to the blade. Only cut materials intended for cutting on the table saw (i.e. hardwood, softwood, plywood, OSB, other wood products, plastics).

How far from the edge of the planner do you keep your hands?

Keep hand(s) at least 12” away from the cutterhead. a. Lay out and mark the exact size of the rabbet on the front edge of the board. Position the fence the width of the rabbet away from the front edge of the table.

What is the minimum distance you should keep your fingers from the blade?

Use both hands and keep fingers at least 4″ from the blade at all times. Keep upper guide within 5mm (1/4″) from the material being cut.

Should the band saw blade break while the machine is in motion?

Do not back the stock away from the blade while the saw is in motion if the work piece binds or pinches on the blade. Do not stop a band saw by thrusting stock against the cutting edge or the side of a blade immediately after the power has been shut off.

When cutting material with a saw what is the minimum distance the hands should be kept from the blade?

4″
Do not make any adjustments without teacher permission. If adjustments permission granted, be sure that power is off. Use both hands and keep fingers at least 4″ from the blade at all times. Keep upper guide within 5mm (1/4″) from the material being cut.

How far away should your hands be from the band saw?

Do not place your fingers close to the saw blade when cutting stock. Always maintain a 4” margin of safety. If it is necessary to back the saw out of a long cut, turn the power off and wait for the blade to stop.

How much space is required between the blade and fence before you do not need a push block?

Generally, a 6” minimum distance to the blade is considered safe, though some recommend 4”. Use a stop block when you crosscut short lengths. Mount a stop block on the fence–this can be as simple as a clamped on board that stops just before the saw blade, so that cut-off pieces cannot bind between blade and fence.

Is it ever acceptable practice to reach over a saw blade explain?

Never reach over the saw blade to remove or hold down a piece of stock. 11. Wait until the blade comes to a complete stop before leaving the table saw work area.

How much can I take off with a planer?

Examine the width of the lumber. Most planers remove a maximum of 3 mm per pass. If a narrow piece of lumber is being planed, the maximum amount may be removed. A piece that it at the maximum width of the planer may cause the motor to overheat and the cutter to stall.

When using miter saw should you never cut wood that is shorter than?

What should you avoid when using a mitre saw? Do not operate the saw when placed on the ground. Do not cut pieces smaller than 20 cm (8 in.) in length.