Admin Is ball joint replacement easy?
Ball joint replacement is not straightforward, as they can be very tricky to access and install – especially with age and rust. On some cars, the ball joint is integrated into the control arm. If you’re not familiar with the suspension and wheel assembly, it’s best to visit a garage for a professional check.
How do I change the wishbone on my Renault Megane?
Its usually, front bumper off, take front crumple panel/subframe off. Then its undo bottom pinch pin for the balljoint, then the rear bolt going up through the subframe, and wishbone, then the front pin. Pull on the hub slightly to allow front part of the wishbone to move out.
How do you replace a ball joint on a car suspension?
If your auto’s suspension uses pressed-in ball joints, you’ll need to remove the lower control arm and take the assembly to a mechanic with a hydraulic press, who can press the old ball joint out and the new ball joint in. Guide the new joint through the knuckle hole.
How do I know if my ball joints need replacing?
There should be no space between the ball joint and the point of contact. If you see any space, or the wheel moves considerably, the joint needs to be replaced. Purchase the correct replacement ball joint assembly for your vehicle. Go to the auto parts store and get a replacement part appropriate for your make and model.
How do you remove a ball joint from a control arm?
Remove the allen bolts and slide the control arm free. Loosen bolts or drill out rivets holding the ball joint in place, and slide out the ball joint. Sometimes, it’s helpful to heat particularly corroded components with a torch to try to loosen them.
How do you remove a ball joint from a steering knuckle?
Removing the Old Ball Joint Pull the cotter pin and loosen the large castellated nut. The top should look like a crown, or castle, at the bottom. Pop loose the ball joint. The goal is to try to guide it through the hole in the upper half of the steering knuckle. Remove the allen bolts and slide the control arm free.