Admin Table of Contents
How many starter shims is too many?
Note: Do not use more than 3 shims on either side. When installing replacement starter motor: DO NOT use an impact gun or breaker bar to tighten bolts!
What causes starter to grind?
Most likely, if it is true grinding that you hear, the problem is related to the starter. Causes include the starter not lining up correctly with the ring gear on the flywheel, missing or damaged gear teeth, or a faulty solenoid. Replacing the starter is most often the right solution.
Does the starter connected to the flywheel?
Your starter is really an electric motor. It engages when you turn the ignition to “run” and turns the engine over allowing it to suck in air. On the engine, a flexplate or flywheel, with a ring gear around the edge, is attached to the end of the crankshaft. The gear meets the flywheel, and the starter turns.
Can a bad starter damage the flywheel?
Since the starter motor pinion material is softer than the flywheel, it is highly unlikely that the starter would ever damage the flywheel teeth.
Why does my Kia Sorento not start up?
The starter motor on your Kia uses energy from the battery to turn the engine over mechanically for starting. This task puts a lot of stress on the pinion gear, which engages the engine flywheel. Eventually, the gear, armature, spring and other internal starter parts wear out and refuse to push-start the engine any more.
How do I replace the starter on my Kia model?
If you find yourself in this situation, you can replace the starter on your Kia model following this guide. Detach the black, negative battery cable using a wrench. Remove the air intake system and any other components necessary to gain access to the starter motor, depending on your particular Kia model.
How do you start a Kia with a floor jack?
Raise the front of your Kia using a floor jack, if the starter motor mounting bolts are installed from the bottom. Then support the vehicle on 2 jack stands. Other Kia models have the mounting bolts installed from the starter or transmission side.
How do you install a starter solenoid on a Ford Ranger?
Start the two mounting bolts by hand to prevent damage to the threads. Tighten the two mounting bolts using the ratchet, socket and a ratchet extension, if necessary. Connect the battery cable and wire to the starter solenoid with the wrench or ratchet and socket. Bolt the wiring cover in place, if equipped.