Admin How do you take a tension pulley off?
Put a socket on the bolt and turn the bolt counterclockwise to break it loose. If it will not break loose because the tensioner wants to move, keep the tensioner from moving by holding it in place with a pry bar; then you will be able to loosen the bolt in the pulley.
How do you release the tensioner pulley on a Ford Ranger?
How to Change a Belt Tensioner on a Ford Ranger
- Put your safety glasses on, raise the hood and locate the belt routing diagram sticker.
- Put the belt tensioner tool into the tensioner and lever it back to release the pressure from the serpentine belt.
How do you change a tensioner belt assembly?
How to replace an accessory tensioner in 8 easy steps
- Draw a sketch or take a picture of the belt routing.
- Unload the belt from the tensioner by rotating the tensioner.
- Remove the old tensioner from the engine.
- Place the new tensioner on the engine.
Is an idler pulley and tensioner pulley the same?
The primary distinction between tensioners and idler pulleys is the presence of an adjustable bolt. Tensioners are positioned on the bolt through mounting. Idler pulleys are not mounted to an adjustable bolt. However, if bearings fail, tensioner and idler pulleys both require replacement.
Are idler pulleys reverse thread?
If it’s just an idler pulley it’s standard. If it’s a tensioner pulley it may be reverse thread depending on the way you need to move the pulley to unload it.
How do you unlock a pulley?
Unlocking a locking pulley is done in reverse. The operator pulls the cord toward the inside, or left, of the pulley. This pulls the small wheel back into alignment and the larger wheel falls back to its original position, releasing the cord.
How does a belt tensioner work on a car?
The belt tensioner assembly of your vehicle is designed to allow several engine parts to be operated by one serpentine belt. The belt is tightened or loosened by adjusting the belt tensioner with a tensioner tool or socket wrench.
Where is the serpentine belt tensioner located on a Chevy Silverado?
The belt tensioner is on the front of the engine, between the crankshaft and alternator pulleys. Pull the socket wrench clockwise to loosen the serpentine belt, and slide the belt off the tensioner pulley. Let the tensioner move back into position. Unbolt the belt tensioner assembly from the motor with a socket wrench.
Why is my tensioner pulley squeaking?
Tensioner pulley wear will cause your pulley to squeak. A worn out pulley bearing or a worn spring in the tension pulley can also cause squeaking or a chirp. I show you how to use water to identify what type of squeak problem you have and then how to find the problem.