Admin How do you remove alternator?
How-To: Replace an Alternator
- Step 1: Disconnect the Battery. First and most importantly: disconnect the battery.
- Step 2: Disconnect the Wires.
- Step 3: Remove the Belt From the Pulley.
- Step 4: Remove Bolts.
- Step 5: Halfway There.
- Step 6: Examine the Replacement.
- Step 7: Reverse the Removal Steps.
- 26 Comments.
What happens when you need an alternator?
If a faulty alternator fails to keep your battery consistently charged, the fuel injectors may not fire, causing your engine to stall. A dying alternator can lead to a wide range of other electrical issues. Generally speaking, such issues manifest as an inability to perform at normal power.
How do you remove an alternator from a car?
Pull the wire from the alternator then pull the alternator out of the engine. Living in Tucson, Ariz., Robert Good has been writing from 2003 on a wide variety of subjects ranging from sports, gardening and cooking to auto repair, home maintenance and travel.
What tools do I need to replace the alternator in my Mercedes-Benz?
These instructions apply to most Mercedes Benz models with the V6 M112 and V8 M113 engines. For this job you will need to have a set of Female E Torx Tool Set which you will need to remove the two bolts that hold the alternator in place. Below is a picture of these sockets and if you need a set you can find them on Amazon for under $20.
How do you remove the drive belt from an alternator pulley?
Remove the drive belt from the alternator pulley by pulling it off of the alternator. Remove the bolts from the rear of the alternator that secure the alternator to the engine with a box wrench set. Two bolts secure the alternator and are located on the rear upper and lower sides of the alternator.
How do you lock the alternator in place?
Tighten the nut for the electrical cable ( positive +) between 15-18Nm. Plug the electrical cable on the back of alternator and make sure it clicks when you push it in. That way you know it is locked in place. Reinstall the serpentine belt, the engine cover and the reconnect the battery. 2 Bolts that hold the alternator in place.