Admin Table of Contents [hide]
How do you remove a GM ignition lock cylinder?
Set the screws aside. Lift the turn signal mechanism up slightly to reveal the ignition lock retainer screw. Remove the screw by turning it counterclockwise with a Phillips head screwdriver. Pull the ignition lock cylinder straight out of the steering column.
Can you replace an ignition switch yourself?
Your ignition switch is the primary part of your electrical system and will fail over time. If you have further issues, or if you are not comfortable replacing the switch yourself, a certified mechanic from YourMechanic can replace your ignition switch for you.
How do you remove a GM ignition switch without the key?
Take your screwdriver and insert it into the ignition lock cylinder. Turn it as far round in a clockwise direction that you can. Then pull the paperclip to the right as much as you can. You should then be able to slide the switch out easily.
How do you change the ignition lock cylinder on a Chevy truck?
How to Change a Chevy Truck Ignition Cylinder
- Remove the screws on the underside of the steering column cover.
- Pull the cover down.
- Push the punch pin up into the access hole under the ignition cylinder.
- Pry the ignition lock out of the steering column with a flat tip screwdriver.
How do you remove the ignition lock cylinder on a Chevy truck without the key?
How do you remove a GM ignition switch?
Removing the Switch Insert the key and turn it to the “start” or “run” position. Now you need a retaining pin—a small, thin metal rod that looks like a lock pick. Push this retaining pin into the hole at the top of the ignition module, and pull the lock cylinder out with the key still inside it.
How do you remove the ignition switch on a Chevy truck?
Do you need a new key when replacing ignition switch?
They tried to jam a screwdriver into the ignition cylinder to turn it on. The new lock cylinder does come with new keys but you would have to use the original key to open the doors or have all of the lock cylinders on the doors and trunk match the new ignition lock cylinder.
Is there a fuse for ignition switch?
It is usually located in the fuse and relay panel beneath the hood, and is responsible for providing power to the vehicle’s ignition system, and some of the fuel system’s components. When the relay fails or has an issue it can cause major problems with the operation of the vehicle.