How do you clear the error code on a Nissan Forklift?

How do you clear the error code on a Nissan Forklift?

To erase your Nissan forklift codes, the repairs must first be made. Following the necessary repairs, return to Diagnostic Mode. Hold the accelerator down for a minimum of 10 seconds, then release the accelerator and the Nissan forklift codes should be erased.

What does e38 mean on a forklift?

DTC E-38 may be set when the fuel pressure in the fuel piping/hose has been abnormally high for a predetermined amount of time. It may set if the sensing circuit is detected open. -check the fuel pressure. Note:The fuel pressure it may read higher than 42kpa.

What does E32 mean on a forklift?

Mitsubishi forklift error codes

What is E27 code on Nissan forklift?

POS sensor error signal
How to clear forklift error code: Caterpillar K21 and K25 Nissan engine

How do you reset a forklift cat?

How do I reset my forklift cat code?

1. Start the stopwatch and turn the forklift key switch on simultaneously.
2. Wait 3 seconds, then press the forklift accelerator five times in.
3. Wait 7 seconds, then press and hold the accelerator for 10 seconds or more until the malfunction indication light starts flashing.

What does F 16 mean on a forklift?

f16 indicates both directions are sending the same signal to the computer for over 2 seconds.. did someone install a back up alarm? you may be going to check ‘pin to pin’ from the directional switch to the ECM.

What does E24 mean on a forklift?

How to clear forklift error code: Mitsubishi

What is a POS sensor on a forklift?

Rear Wheels. The angle position sensor or multi-turn angle sensor installed on the rear wheels measures or detects the turning angle or direction of the rear wheels.