Admin How do you adjust an atomic clock?
Atomic Clocks may also be set manually and be very accurate. Simply insert the battery, press your time zone and then press the flap just above the left side of the battery. Hold until you reach the correct time and then release. Your clock is now an accurate quartz clock until it will find the signal.
Why won’t my atomic clock set itself?
Try powering down the clock (unplug it or remove the batteries), then turn it on again to see if it synchronizes. If the clock uses batteries, check them and replace if necessary. If the radio controlled clock is a desk top unit, try rotating it 90 degrees.
How do you set an atomic wall clock?
Setting an atomic wall clock is simple. Insert the correct number of fresh AA LR6 alkaline batteries in the battery compartment according to the polarity markings. It’s best to do this late in the evening because longwave radio signals are normally not received during the day.
How do I Set my clock to the correct time?
Place your clock in an upright position near a window to help it find its initial signal. Within a few minutes, your clock will find the WWVB signal and set itself to the correct time or decide that it can’t receive the signal at this location and time of day.
How do I set the time zone on the skyscan atomic clock?
The SkyScan atomic clock can only collect the correct signal from 2,000 miles (3,200 km) away, so it must be set to the correct zone to get an accurate reading. Press and hold one of the four time zone buttons MT-Mountain Time, CT-Central Time, ET-Eastern Time, and PT-Pacific Time. Clocks tend to automatically default to a Pacific area time zone.
How do I use the Rec button on my Clock?
· During normal run time, press the REC button for 3 seconds. The hands stop moving and the clock starts searching for the radio signal. (There are 2 REC buttons on the back of your clock and you may use either one.) · If reception is successful, the hands synchronize to the correct time.