Table of Contents
How do I know if my lawn tractor ignition switch is bad?
To check your ignition switch, you can use an ohmmeter to see if there is any connection between the “S” and “B” terminals. If there isn’t any, the ignition switch is your problem and you will need to replace it to get your mower running properly again.
How can you tell if your ignition switch is bad?
Put the ignition key into the ignition switch and crank the engine. If the engine cranks, then your ignition switch is obviously working fine. If the engine does not crank, and you hear a “click” when you first turn the key to the “III” position, then your ignition switch is not the problem.
Where is the safety switch on a yard machine riding mower?
Yard Machines have a safety switch by the clutch brake pedal, which you must completely depress when starting the mower. Other safety switches are located by the lift and shift levers, and under the seat.
Why won’t my Husqvarna lawn tractor start?
A tractor mower won’t start if the blade lever/button is on, manual mowers need to be in Neutral gear, some mowers won’t allow starting if the oil level is low or the hood is open. If your in any doubt about the correct starting procedure for a lawn tractor, check out – ” How to Start Husqvarna Ride-on Mower”.
What should I do if my lawn mower wont start?
Check the ignition wiring for damage, corrosion or loose wires. Have a helper sit on the mower and attempt a start while you wiggle the ignition wires and connectors. Check ignition inputs – ground and 12 volt supply. Check ignition outputs – 12v to the starter solenoid (or to the Control module if fitted) when ignition is in the start position.
Why won’t my starter solenoid coil turn over?
If it turns over, the grounded side of the solenoid coil is fine. This is likely the case. If it does not turn over, you have a problem with the black ground wire. At this point you’ve determined you have a good solenoid and starter and that the solenoid is grounded properly.
Can you jump start a lawn mower without a battery charger?
If you don’t have a charger – no problem, go ahead and jump start your mower. (see below) Check battery state of charge – Very low volts, it’s likely the battery is faulty and will not recharge. Check the main fuse – all mowers will have one, the hard part is finding it.
https://www.youtube.com/watch?v=s8ed27uFiz4