Admin Table of Contents [hide]
Can you just replace the timing belt tensioner?
When the timing belt is replaced, other parts, including the tensioner, should be replaced at the same time. This is because these components wear out at essentially the same rate as the belt. For instance, the tensioner bearings could dry out or even seize.
Does a Fiat Panda 1.2 have a Cambelt?
This engine has a timing chain, but its lifer depends on running in clean oil.
Is Fiat Panda reliable?
Is a used Fiat Panda hatchback reliable? The Panda has always had a mixed reliability record. In the most recent survey in which it featured, it finished near the bottom in the city car class, although only 20% of owners actually reported problems.
How do I know if my timing belt tensioner is bad?
Symptom 1: Squealing, rattling, or chirping. When the tensioner or tensioner pulley fails, the loss of tension can cause the belt and pulleys to make high-pitched rattling or chirping noises. If the pulley bearing completely fails, it can also cause a squealing or even a grinding noise.
Is Fiat Panda 1.2 a good car?
With decent ride comfort, sprightly handling and excellent all-round visibility, the Panda is a terrific town car. Interior trim quality doesn’t always match that of rivals, but the Panda has a solid reputation for reliability in our Driver Power satisfaction surveys.
Does a Fiat Panda have a Cambelt?
The experts at ContiTech provide a step-by-step explanation of how to change the timing belt correctly in a Fiat Panda. The manufacturer recommends changing the timing belt every 120,000km/10 years. The labour time is just over one and a half hours.
How long does it take to change a Fiat Panda timing belt?
The experts at ContiTech provide a step-by-step explanation of how to change the timing belt correctly in a Fiat Panda. The manufacturer recommends changing the timing belt every 120,000km/10 years. The labour time is just over one and a half hours.
How often do you change your cam belt?
Even though my low mileage isn’t due to standing for long periods; it gets used every work day, but for short distances, 4kms in the morning and again in the afternoon. Re: Cam belt change – when? Autodata says 40k or 4 years, depending on which comes 1st.
How do you tension a timing belt with a pulley?
3. Pretension the timing belt via tensioning pulley. To do so, insert tensioning wrench into tensioning pulley, turn tensioning pulley counter clockwise, and tension to either 7Nm (see below). or approx. 250 Hz. Position measurement head of BTT Hz in correct location approx. 1-2 cm above timing belt.
How do you fit a water pump to a timing belt?
Fit new components from timing belt kit. Sparingly apply sealant to water pump flange groove (see below).. After fitting water pump (10Nm), wait at least one hour before filling with coolant and fitting timing belt (vulcanisation time for adhesive).