Admin Table of Contents
What does it mean when it says service tire monitoring system?
What is a Service Tire Monitor System? Whenever your car says service tire monitor system, this means that more than likely you have a bad tire pressure monitor sensor (TPMS). A TPMS or service tire monitor system, just lets you know when your tire pressure is too low or too high.
How do you reset the service tire monitor system on a 2008 Chevy Impala?
Once Your tires are all filled then You can go ahead and simply reset the TPMS. To do t his You will need to press and hold the Check icon button below the “i” button. Hold this until the TPMS light blinks on the dash. Once that happens You have reset the system and You can drive off.
How much does it cost to repair a service tire monitor?
The service kit costs $5-$10 per wheel on most vehicles. A special TPMS tool and additional time are also needed to check and reset the sensor system. In the event pressure sensors need to be replaced, the cost ranges from $50-$250 each depending on vehicle type.
What does Service tire Monitor system mean on a Chevy Silverado?
In most cases, when the tire pressure monitoring system (TPMS) light on the dashboard comes on, it indicates that the air pressure in one or more of your tires has fallen below the recommended level.
How do I reset the Service tire Monitor system?
Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh. The TPMS reset button is usually located beneath the steering wheel. If you are unable to find it, refer to your vehicle’s owner’s manual.
How do you reset the SVC tire monitor on a Chevy Malibu?
How To Easily Reset Tire Pressure TPMS Light on Chevrolet Malibu (2008-2021)
- Turn the ignition key to the “ON” position without starting the engine.
- Press the Remote Keyless Entry (RKE) transmitter’s LOCK and UNLOCK buttons simultaneously for five seconds.
- Activate the TPMS sensor.
How do I turn off my service tire monitor?
With the vehicle off, turn the key to the “on” position, but don’t start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh. The TPMS reset button is usually located beneath the steering wheel.