Admin Table of Contents
What does perform service on a vehicle mean?
What Does Perform Service Mean? Most of the time, this light refers to when you need to change your oil. Other car manufacturers have similar indicators where they let you know it is time to change the oil.
How do I get rid of perform service on Jeep Grand Cherokee?
How to Reset the Jeep Grand Cherokee Service Required Message
- Turn the ignition switch to the “ON” position without starting the vehicle.
- Press the gas pedal to the floor slowly three times within 10 seconds.
- Turn the ignition off. Wait 10 seconds and start the engine.
What is included in a jeep service?
48,000 Miles / 36 Months
- Change the engine oil and engine oil filter.
- If using your vehicle for any of the following: Dusty or off-road conditions.
- Replace the air conditioning filter.
- Inspect the brake linings, replace if necessary.
- Inspect the CV joints.
- Inspect exhaust system.
What is service required?
The service required light is mainly used to remind drivers when it is time to change the oil and filter, but could be used for other fluids or components. In the past, this light was similar to the check engine light and could mean that a fault has been detected by the system.
What does it mean when your service light comes on?
The service required light just means the car is due for an oil change or other routine care. It is not an indicator of trouble like the check engine light is. Your local mechanic can usually diagnose the problem for about $75.
What does perform service mean on a 2006 Jeep Grand Cherokee?
Needs to perform the manufacturer’s suggested maintenance service. It could be as simple as an oil and filter change – based on mileage and previous maintenance records. After the service the repair shop will reset the warning light.
How do I get rid of Jeep perform service?
How to Reset Perform Maintenance on a Jeep Liberty
- Turn on the engine.
- On the vehicle’s dash, press the “Step” button until “Miles to Service” is displayed.
- Press and hold the “Reset” button, near the “Step” button, until the “Miles to Service” flashes and resets. Verify the “Perform Service” light goes away.
What is a Jeep 4×4 service?
Four-wheel drive vehicles demand rugged performance from their transmissions, especially when used for off-road driving or towing. Our 4×4 services include: Draining and refilling the Transfer Case with fresh, clean fluid. Draining and refilling the Front Differential with fresh, clean fluid.
How often does a jeep need an oil change?
every 7,500 to 10,000 miles
Most experts recommend a Jeep oil change every 7,500 to 10,000 miles, but a lot depends on your driving habits.
Why is my service light on in my car?
As mentioned earlier, the service required light is mainly used to remind drivers to change the oil and filter. When the light illuminates, you should take the car to be serviced at your convenience. After the repair work is done, a reset procedure is usually necessary to turn the light off.