Admin Table of Contents
How do I find the gear ratio on my Toyota VIN number?
It can be found on the sticker on the inside of the driver’s side door or on a stamped metal plate embedded in the dashboard above the steering wheel. It also is on your vehicle’s title.
Is a 4.56 gear ratio good?
One of the most important aspects of building any vehicle is choosing the proper gear ratio for the wheels and tires. That’s why I run a 4.56 gear ratio with 35″ tires. This gives me decent fuel efficiency at highway speeds, and enough low end power to throttle through difficult obstacles.
Is 4.56 a low gear ratio?
Tall (high) gears have LOWER numerical numbers such as 2.79, 2.90, 3.00, 3.25. Short (low) gears have HIGHER numerical numbers, such as 4.11, 4.30, 4.56, 4.88, 5.13, 5.36, etc. That’s a low gear ratio.
How fast can you go with 4.56 gears?
your max highway speed will be about 138mph @ 5000rpms with 4.56s & 33s. personally, I wouldn’t recommend driving a TJ that fast.
How do I know my axle gear ratio?
Method 1: Count the number of teeth on the ring gear and the pinion. Divide the number of the ring gear’s teeth by the number of the pinion’s teeth. This will give you the axle ratio.
What gear ratio is a Dana 35?
3.08-5.13 Ratio
Dana 35 3.08-5.13 Ratio.
What is the gear code on a Toyota pickup truck?
The gear code for all Toyota pickups, is a 4 digit code with one letter and three numbers on earlier models and one letter, two numbers and one letter on later models. Referring to the top example above, the first letter in the code “G” denotes the ring gear diff size of the rear axle.
What is the correct gear ratio for my tires?
I.E. if you have 31″ tires, you should use 4.88 gears, if you have 33″ tires, you should use 5.29 gears. The lower gearing is recommended to offset the extremely high 1st gear in the automatic and the high overdrive. Toyota installed 4.30s in stock automatics, while similar 5 speed models got 4.10 gears.
Where is the gear code on a 1989 Toyota 4×4?
Above, is a typical 1989 and later VIN plate, located on the driver’s door jam. This one is from a 1989 Toyota 4X4. The gear code is circle in red and is G292, which indicates an 8″ rear diff with 4.10 gears and a 2 pinion carrier.
What is considered a low gear ratio?
“Low” gears are numerically high. 5.71s are on the “low” side for modified Toys. You’d get super fast and torquey takeoffs from a dead stop, but you’d be limited to a pretty low top speed since the engine would be running at such a high RPM.