Admin Table of Contents
How do I fix a pick motor stalled on my HP printer?
The “Pick Motor Stalled” Error Appears
- Turn the printer on and wait until the printer is silent.
- With the printer on, disconnect the power cord from the rear of the printer and unplug the power cord from the outlet.
- Wait at least 60 seconds.
How do I reset my HP OfficeJet Pro 8600 Plus?
Resetting the HP OfficeJet Pro 8600 printer if it’s not working
- Turn off your Officejet Pro 860 printer.
- Count 10 seconds, then turn it ON again.
- Once the printer is ON, push the back button on the printer’s front panel four times.
- The support menu will appear if you do this correctly.
How do I Unjam my HP OfficeJet Pro 8600?
Clear jammed paper from Tray 1
- Press the Power button to turn off the printer.
- Disconnect the power cord from the rear of the printer.
- Remove all paper from the output tray.
- Place your fingers in the slot on the front of Tray 1.
- Pull the tray toward you to remove it.
How do I manually clean my HP OfficeJet Pro 8600?
To clean the printhead, go to Tools on the printer control panel.
- Load plain white paper into the tray.
- On the printer control panel, touch the Right Arrow ( ) to display additional options.
- Touch Setup ( ), and then touch Tools.
- Touch Clean Printhead.
How do you clean the rollers on a HP OfficeJet Pro 8600?
Lightly dampen a clean, lint-free cloth with bottled or distilled water, and then squeeze any excess liquid from the cloth. Press the cloth against the roller, and then rotate the roller with your fingers. Apply a moderate amount of pressure to remove any dust or dirt buildup. Repeat this step for each roller.
Why does my HP printer Say error?
If your printer’s status displays “Printer in error state,” there may be a problem with the printer itself. Make sure the printer is turned on and connected to your PC by Wi-Fi or cable. Check it for low paper or ink, and be sure the cover isn’t open and the paper isn’t jammed.
How do I hard reset my HP printer?
To restore the product to the factory-default settings, follow these steps.
- Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect.
- Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on.
- Release the Resume button.
What is Oobe reset?
The Windows Out Of Box Experience (OOBE) resets a number of user interface and configuration options, allowing you to make new choices similar to those offered when Windows was first set up.
Can I use vinegar to clean printhead?
If gently cleaning the printhead nozzles hasn’t been successful, you can soak the printhead to loosen any dried ink. Fill a bowl with warm water (or a mixture of water and vinegar to clean the printhead) and place the printhead directly in it. Let it sit for five minutes or so.