Admin Table of Contents
What is an input list for a band?
mixer inputs
An input list is a list of the number of outputs the band or performers have for their instruments, equipment and vocals and the number of audio mixer inputs needed.
What are stage inputs?
The task of the input stage is to process the differential signals present at the inputs of the operational amplifier while keeping the amount of interference that is added by the input stage as small as possible. Interference includes offset, noise, and distortion.
What are 3 things you would out on a stage plot?
Every touring band needs a stage plot….What do I include?
- Visual representation of where each member is positioned on stage.
- The names of each member and what instruments they play.
- How many mics, DIs, monitors, and cables (XLRs or 1/4 inch) you’ll need the venue to provide.
- What sound gear, if any, you’ll be providing.
What do you put in the input list?
Input lists should include every instrument, every DI, and every vocal, says Loop. As advised in our recent stage plot post, if you’re not sure what inputs each instrument or musician needs, ask your bandmates. There may be instrument-specific input or miking details you may never have expected.
What is a tech spec for a band?
A band may provide a tech spec to a promoter or venue that outlines what equipment and conditions are required for them to do their show to the highest standard. This will typically include preferred audio equipment, an input list, monitor list and a stage plot.
What is output stage?
The output stage is the part between the analog converter and the cinch sockets on the back. Here is the final processing of the now analog audio signal of the converter instead. With the principle of a voltage follower of the buffer, there is no amplification and at best no change of the audio signal.
What is used as an input stage of IC opamp?
An op amp with an NPN input stage works in a similar way around the positive supply rail. There are both PNP and NPN differential amplifiers used in the input stages of the RRI op amp; thus the RRI op amp can operate above and below the power supply voltage.
What are 3 things that need to be on an input list?
Input lists should include every instrument, every DI, and every vocal, says Loop. As advised in our recent stage plot post, if you’re not sure what inputs each instrument or musician needs, ask your bandmates.
What is MAP INT input () split ())?
n, S = map(int, input().split()) will query the user for input, and then split it into words, convert these words in integers, and unpack it into two variables n and S . This thus will succeed when the user enters two numbers (not more, not less).