Admin Table of Contents
- 1 Where is the starter relay 2006 Dodge Ram 2500?
- 2 Where is the starter relay on a 2007 Dodge Ram 2500?
- 3 Where is the starter relay on a 2008 Dodge Ram 2500?
- 4 Where is the starter motor located on a Dodge Ram 1500?
- 5 How do you attach the starter to the transmission?
- 6 Where do the wires go on a starter?
Where is the starter relay 2006 Dodge Ram 2500?
The starter relay for a 2006 dodge ram pickup 2500 is located on the left inner fender in front of the battery.
Where is the starter relay on a 2007 Dodge Ram 2500?
The 2007 Dodge Ram 2500 starter relay location is in the fuse box. To get to the fuse box look to the left of the steering wheel look for a small seam or crack along the dash. Using a screwdriver or prybar You will want to pop this open.
Where is the starter relay on a 2008 Dodge Ram 2500?
Registered. The starter relay is located inside the power distribution center a black box located next to the driverside battery.
Where is the starter relay on a 2008 Dodge Ram?
The starter relay in a 2008 ram 1500 is located in the main fuse panel under the hood.
Where is the starter relay located on a 2008 Dodge Ram?
This is basically an under hood fuse box towards the windshield on the passenger side. It appears to be mounted on the firewall.
Where is the starter motor located on a Dodge Ram 1500?
The starter motor contains the electric motor, the drive mechanism, and the solenoid. On the Dodge Ram 1500, it can be found connected to the driver’s side of the transmission.
How do you attach the starter to the transmission?
Two bolts with 14mm heads hold the starter to the transmission. The first bolt will require the use of an extension (about 4-6 inches). The second bolt is closer to the tire, but it’s harder to see. It is surrounded by a black plate/bracket that is attached to the transmission.
Where do the wires go on a starter?
Two wires are attached to the starter. The smaller wire runs from the ignition switch to the starter, and it is held in place by a plastic clip. This clip slides onto a metal tab on the starter. Squeeze the larger portion of the plastic clip (you will feel the clip compress), and slide the clip off the metal tab.
How do I remove the Starter Cable from the battery?
Use a 10mm wrench to remove the negative (black) cable from the battery. Place the cable in an area where it will not accidentally contact the battery, or wrap the cable in electrical tape. Crawl under the driver’s side of the truck. Near the driver’s side tire you will see the starter between the engine and transmission above the exhaust.